Initial commit

target/linux/kirkwood/patches-4.9/105-ea4500.patch

@@ -0,0 +1,64 @@
+--- a/arch/arm/boot/dts/kirkwood-linksys-viper.dts
++++ b/arch/arm/boot/dts/kirkwood-linksys-viper.dts
+@@ -69,6 +69,17 @@
+ 		};
+ 	};
+ 
++	mvsw61xx {
++		compatible = "marvell,88e6171";
++		status = "okay";
++		reg = <0x10>;
++
++		mii-bus = <&mdio>;
++		cpu-port-0 = <5>;
++		cpu-port-1 = <6>;
++		is-indirect;
++	};
++
+ 	dsa {
+ 		compatible = "marvell,dsa";
+ 		#address-cells = <2>;
+@@ -161,22 +172,22 @@
+ 		};
+ 
+ 		partition@200000 {
+-			label = "kernel";
++			label = "kernel1";
+ 			reg = <0x200000 0x2A0000>;
+ 		};
+ 
+ 		partition@4A0000 {
+-			label = "rootfs";
++			label = "rootfs1";
+ 			reg = <0x4A0000 0x1760000>;
+ 		};
+ 
+ 		partition@1C00000 {
+-			label = "alt_kernel";
++			label = "kernel2";
+ 			reg = <0x1C00000 0x2A0000>;
+ 		};
+ 
+ 		partition@1EA0000 {
+-			label = "alt_rootfs";
++			label = "rootfs2";
+ 			reg = <0x1EA0000 0x1760000>;
+ 		};
+ 
+@@ -225,10 +236,14 @@
+ };
+ 
+ /* eth1 is connected to the switch at port 6. However DSA only supports a
+- * single CPU port. So leave this port disabled to avoid confusion.
++ * single CPU port. Upstream uses DSA so they disable this port to avoid confusion.
+  */
+ &eth1 {
+-	status = "disabled";
++	status = "okay";
++	ethernet1-port@0 {
++		speed = <1000>;
++		duplex = <1>;
++	};
+ };
+ 
+ /* There is no battery on the board, so the RTC does not keep