ath79: add support for TP-Link TL-WR941HP v1
Specifications:
SOC: Qualcomm Atheros TP9343 (750 MHz)
Flash: 8 Mb (GigaDevice GD25Q64CSIG)
RAM: 64 Mb (Zentel A3R12E40DBF-8E)
Serial: yes, 4-pin header
Wlan: Qualcomm Atheros TP9343, antenna: MIM0 3x3:3 RP-SMA
3 x 2.4GHz power amp module Skyworks (SiGe) SE2576L
Ethernet: Qualcomm Atheros TP9343
Lan speed: 100M ports: 4
Lan speed: 100M ports: 1
Other info: same case, ram and flash that TP-Link TL-WR841HP,
different SOC
https://forum.openwrt.org/t/adding-device-support-tp-link-wr941hp/
Label MAC addresses based on vendor firmware:
LAN *:ee label
WAN *:ef label +1
WLAN *:ee label
The label MAC address found in "config" partition at 0x8
Flash instruction:
Upload the generated factory firmware on web interface.
Signed-off-by: Diogenes Rengo <rengocbx250@gmail.com>
[remove various whitespace issues, squash commits, use short 0x0]
Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
This commit is contained in:
Diogenes Rengo
committed by
Adrian Schmutzler
Adrian Schmutzler
parent
12eb5b2384
commit
cce2e8db56
154
target/linux/ath79/dts/tp9343_tplink_tl-wr941hp-v1.dts
Normal file
154
target/linux/ath79/dts/tp9343_tplink_tl-wr941hp-v1.dts
Normal file
@@ -0,0 +1,154 @@
|
||||
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
|
||||
|
||||
#include "qca956x.dtsi"
|
||||
|
||||
#include <dt-bindings/gpio/gpio.h>
|
||||
#include <dt-bindings/input/input.h>
|
||||
|
||||
/ {
|
||||
compatible = "tplink,tl-wr941hp-v1", "qca,tp9343";
|
||||
model = "TP-Link TL-WR941HP v1";
|
||||
|
||||
aliases {
|
||||
label-mac-device = &wmac;
|
||||
led-boot = &led_power;
|
||||
led-failsafe = &led_power;
|
||||
led-running = &led_power;
|
||||
led-upgrade = &led_power;
|
||||
};
|
||||
|
||||
leds {
|
||||
compatible = "gpio-leds";
|
||||
|
||||
re {
|
||||
label = "blue:re";
|
||||
gpios = <&gpio 6 GPIO_ACTIVE_LOW>;
|
||||
};
|
||||
|
||||
wifi {
|
||||
label = "blue:wifi";
|
||||
gpios = <&gpio 8 GPIO_ACTIVE_LOW>;
|
||||
linux,default-trigger = "phy0tpt";
|
||||
};
|
||||
|
||||
led_power: power {
|
||||
label = "blue:power";
|
||||
gpios = <&gpio 18 GPIO_ACTIVE_LOW>;
|
||||
default-state = "on";
|
||||
};
|
||||
|
||||
wan_blue {
|
||||
label = "blue:wan";
|
||||
gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
|
||||
};
|
||||
|
||||
wan_red {
|
||||
label = "red:wan";
|
||||
gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
|
||||
};
|
||||
|
||||
lan {
|
||||
label = "blue:lan";
|
||||
gpios = <&gpio 7 GPIO_ACTIVE_LOW>;
|
||||
};
|
||||
|
||||
wps {
|
||||
label = "blue:wps";
|
||||
gpios = <&gpio 3 GPIO_ACTIVE_LOW>;
|
||||
};
|
||||
};
|
||||
|
||||
keys {
|
||||
compatible = "gpio-keys";
|
||||
|
||||
re {
|
||||
label = "range extender button";
|
||||
linux,code = <BTN_0>;
|
||||
gpios = <&gpio 5 GPIO_ACTIVE_LOW>;
|
||||
debounce-interval = <60>;
|
||||
};
|
||||
|
||||
wifi {
|
||||
label = "wifi button";
|
||||
linux,code = <KEY_RFKILL>;
|
||||
gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
|
||||
debounce-interval = <60>;
|
||||
};
|
||||
|
||||
reset {
|
||||
label = "reset button";
|
||||
linux,code = <KEY_RESTART>;
|
||||
gpios = <&gpio 1 GPIO_ACTIVE_LOW>;
|
||||
debounce-interval = <60>;
|
||||
};
|
||||
|
||||
wps {
|
||||
label = "wps button";
|
||||
linux,code = <KEY_WPS_BUTTON>;
|
||||
gpios = <&gpio 4 GPIO_ACTIVE_LOW>;
|
||||
debounce-interval = <60>;
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&spi {
|
||||
status = "okay";
|
||||
|
||||
flash@0 {
|
||||
compatible = "jedec,spi-nor";
|
||||
reg = <0>;
|
||||
spi-max-frequency = <25000000>;
|
||||
|
||||
partitions {
|
||||
compatible = "fixed-partitions";
|
||||
#address-cells = <1>;
|
||||
#size-cells = <1>;
|
||||
|
||||
uboot: partition@0 {
|
||||
label = "u-boot";
|
||||
reg = <0x0 0x020000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
partition@20000 {
|
||||
compatible = "tplink,firmware";
|
||||
label = "firmware";
|
||||
reg = <0x020000 0x730000>;
|
||||
};
|
||||
|
||||
config: partition@750000 {
|
||||
label = "config";
|
||||
reg = <0x750000 0x0a0000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
art: partition@7f0000 {
|
||||
label = "art";
|
||||
reg = <0x7f0000 0x010000>;
|
||||
read-only;
|
||||
};
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
ð0 {
|
||||
status = "okay";
|
||||
|
||||
phy-handle = <&swphy0>;
|
||||
|
||||
mtd-mac-address = <&config 0x8>;
|
||||
mtd-mac-address-increment = <1>;
|
||||
};
|
||||
|
||||
ð1 {
|
||||
status = "okay";
|
||||
|
||||
mtd-mac-address = <&config 0x8>;
|
||||
};
|
||||
|
||||
&wmac {
|
||||
status = "okay";
|
||||
|
||||
mtd-cal-data = <&art 0x1000>;
|
||||
mtd-mac-address = <&config 0x8>;
|
||||
};
|
||||
@@ -374,6 +374,10 @@ tplink,tl-wr842n-v2)
|
||||
ucidef_set_led_switch "lan3" "LAN3" "green:lan3" "switch0" "0x10"
|
||||
ucidef_set_led_switch "lan4" "LAN4" "green:lan4" "switch0" "0x02"
|
||||
;;
|
||||
tplink,tl-wr941hp-v1)
|
||||
ucidef_set_led_netdev "wan" "WAN" "blue:wan" "eth1" "link tx rx"
|
||||
ucidef_set_led_switch "lan" "LAN" "blue:lan" "switch0" "0x1e"
|
||||
;;
|
||||
trendnet,tew-823dru)
|
||||
ucidef_set_led_netdev "wan" "WAN" "green:planet" "eth0"
|
||||
;;
|
||||
|
||||
@@ -398,7 +398,8 @@ ath79_setup_interfaces()
|
||||
ucidef_add_switch "switch0" \
|
||||
"0@eth0" "2:lan:3" "3:lan:2" "4:lan:1" "5:lan:4"
|
||||
;;
|
||||
tplink,tl-wr842n-v2)
|
||||
tplink,tl-wr842n-v2)\
|
||||
tplink,tl-wr941hp-v1)
|
||||
ucidef_set_interface_wan "eth1"
|
||||
ucidef_add_switch "switch0" \
|
||||
"0@eth0" "1:lan:4" "2:lan:1" "3:lan:2" "4:lan:3"
|
||||
|
||||
@@ -798,6 +798,16 @@ define Device/tplink_tl-wr902ac-v1
|
||||
endef
|
||||
TARGET_DEVICES += tplink_tl-wr902ac-v1
|
||||
|
||||
define Device/tplink_tl-wr941hp-v1
|
||||
$(Device/tplink-safeloader)
|
||||
SOC := tp9343
|
||||
DEVICE_MODEL := TL-WR941HP
|
||||
DEVICE_VARIANT := v1
|
||||
TPLINK_BOARD_ID := TL-WR941HP-V1
|
||||
IMAGE_SIZE := 7360k
|
||||
endef
|
||||
TARGET_DEVICES += tplink_tl-wr941hp-v1
|
||||
|
||||
define Device/tplink_wbs210-v1
|
||||
$(Device/tplink-safeloader-okli)
|
||||
SOC := ar9344
|
||||
|
||||
@@ -1930,6 +1930,37 @@ static struct device_info boards[] = {
|
||||
.last_sysupgrade_partition = "file-system",
|
||||
},
|
||||
|
||||
/** Firmware layout for the TL-WR941HP v1 */
|
||||
{
|
||||
.id = "TL-WR941HP-V1",
|
||||
.vendor = "",
|
||||
.support_list =
|
||||
"SupportList:\n"
|
||||
"{product_name:TL-WR941HP,product_ver:1.0.0,special_id:00000000}\n",
|
||||
.part_trail = 0x00,
|
||||
.soft_ver = NULL,
|
||||
|
||||
.partitions = {
|
||||
{"fs-uboot", 0x00000, 0x20000},
|
||||
{"firmware", 0x20000, 0x730000},
|
||||
{"default-mac", 0x750000, 0x00200},
|
||||
{"pin", 0x750200, 0x00200},
|
||||
{"product-info", 0x750400, 0x0fc00},
|
||||
{"soft-version", 0x760000, 0x0b000},
|
||||
{"support-list", 0x76b000, 0x04000},
|
||||
{"profile", 0x770000, 0x04000},
|
||||
{"default-config", 0x774000, 0x0b000},
|
||||
{"user-config", 0x780000, 0x40000},
|
||||
{"partition-table", 0x7c0000, 0x10000},
|
||||
{"log", 0x7d0000, 0x20000},
|
||||
{"radio", 0x7f0000, 0x10000},
|
||||
{NULL, 0, 0}
|
||||
},
|
||||
|
||||
.first_sysupgrade_partition = "os-image",
|
||||
.last_sysupgrade_partition = "file-system",
|
||||
},
|
||||
|
||||
/** Firmware layout for the TL-WR942N V1 */
|
||||
{
|
||||
.id = "TLWR942NV1",
|
||||
|
||||
Reference in New Issue
Block a user