982468de35
Move the USB VBUS regulator nodes out of the GPIO controller node. This fixes a problem where the "regulator-fixed" driver wasn't probed for these regulators because the GPIO driver doesn't scan the child-nodes and based on the dt-bindings documentation it's not supposed to. This fixed the following error reported by Luca Olivetti: ... dwc2 1e101000.usb: DWC OTG Controller dwc2 1e101000.usb: new USB bus registered, assigned bus number 1 dwc2 1e101000.usb: irq 62, io mem 0x1e101000 dwc2 1e101000.usb: startup error -517 dwc2 1e101000.usb: USB bus 1 deregistered dwc2 1e101000.usb: dwc2_hcd_init() FAILED, returning -517 Fixes: FS#1634 Cc: Luca Olivetti <luca@ventoso.org> Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
_______ ________ __
| |.-----.-----.-----.| | | |.----.| |_
| - || _ | -__| || | | || _|| _|
|_______|| __|_____|__|__||________||__| |____|
|__| W I R E L E S S F R E E D O M
-----------------------------------------------------
This is the buildsystem for the OpenWrt Linux distribution.
To build your own firmware you need a Linux, BSD or MacOSX system (case
sensitive filesystem required). Cygwin is unsupported because of the lack
of a case sensitive file system.
You need gcc, binutils, bzip2, flex, python3.5+, perl, make, find, grep, diff,
unzip, gawk, getopt, subversion, libz-dev and libc headers installed.
1. Run "./scripts/feeds update -a" to obtain all the latest package definitions
defined in feeds.conf / feeds.conf.default
2. Run "./scripts/feeds install -a" to install symlinks for all obtained
packages into package/feeds/
3. Run "make menuconfig" to select your preferred configuration for the
toolchain, target system & firmware packages.
4. Run "make" to build your firmware. This will download all sources, build
the cross-compile toolchain and then cross-compile the Linux kernel & all
chosen applications for your target system.
Sunshine!
Your OpenWrt Community
http://www.openwrt.org